Auto Settings

Auto Settings

It sets parameters for full auto function.

Interface:

1. Infinite Play

If this option is set, when full auto function has started, it will automatically solving puzzle until invalid puzzle format read(probaly game finished or game over) or unknow error occurs.

2. Number of Execution

If Infinite Play has not set, full auto function will be run with limited number of excutions.

3. Set Retry Limit

Enable setting of retry limit(Keep it checked).

4. Retry Limit

Set number of retry when getting invalid puzzle. Full auto function will be stopped when this limit got exceeded.

Note: For fast device, it is good to have higher retry limit.

5. Move time limit

Set time to auto move an orb following computed path. Good to keep at 3~4 seconds if no specific requirement.

6. Move Speed

Define how fast it moves. Smaller value for faster move.

7. Gap

Define time between each screenshot.

8. Time Gap After Move

Define time delay for solving next puzzle.

9. Adjust Recovery Weighting

If checked, recovery orb get higher chance to form a combo if HP is lower than Target HP.

10. Target HP

Set target HP percentage for auto adjustment of recovery orb combo.

11. Auto Trigger Skill(For Tower of Savior)[Testing funtion]

a. Enable

Allow auto trigger of skill of that member.

b. Repeat Trigger

Allow repeatedly triggering of skill of that member.

c. Capture Again

Since some skills will change the puzzle after triggering, so we must capture again to get the new puzzle.

Note 1: Not applicable for member with more than 1 skill.

Note 2: May has chance wasting magic stones.

Note 3: Not applicable for detecting special skills.

Orb Master @ 2014